Custom Search

To advertise on this site email advertise@goatnetworking.com

How to set the channels on a Cisco 7921G wireless phone

Site Admin
User avatar
Posts: 369
Joined: Wed Jan 04, 2012 2:36 pm

How to set the channels on a Cisco 7921G wireless phone

Postby admin » Thu May 03, 2012 3:57 pm

Here is how to set the channels on a 7921G.

1. Enable the web access in CUCM.. (Versions may differ)

You have to set "Web Access*" to Full, then check the box to the right. (This is located on the phone configuration page in CUCM)

Then enter a password in the "Admin Password" field

2. Go to the phones web page https://<IP Address>

- Admin is the username

- Enter the password you entered into CUCM

3. Go to the Profile page, click Advanced in the upper right.

- You then select the channels that you want to use.

You need to set the channels on the wireless network to match the channels that you are scanning on the phone. If the phone is not scanning the channel that you have on an AP, the phone will not see it.


Return to Wireless

Twitter Facebook

Who is online

Users browsing this forum: No registered users and 1 guest